Skip to content
doubtly
Chapter: Electricity· Science

Explain the following. (a) Why is the tungsten used almost exclusively for filament of electric lamps?

Explain the following.
(a) Why is the tungsten used almost exclusively for filament of electric lamps?
(b) Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal?
(c) Why is the series arrangement not used for domestic circuits?
(d) How does the resistance of a wire vary with its area of cross-section?
(e) Why are copper and aluminium wires usually employed for electricity transmission?
Doubtly Asked Updated Student doubt Save WhatsApp Report

2 answers

Best answer

a) The melting point and of Tungsten is an alloy which has very high melting point and very high resistivity so does not burn easily at a high temperature.

b) The conductors of electric heating devices such as bread toasters and electric irons are made of alloy because resistivity of an alloy is more than that of metals which produces large amount of heat.

c) In series circuits voltage is divided. Each component of a series circuit receives a small voltage so the amount of current decreases and the device becomes hot and does not work properly. Hence, series arrangement is not used in domestic circuits.

d) Resistance (R) of a wire is inversely proportional to its area of cross-section (A), i.e. when area of cross section increases the resistance decreases or vice versa.

e) Copper and aluminium are good conductors of electricity also they have low resistivity. So they are usually used for electricity transmission.

Doubtly · 14 Dec 2021 Report
Was this answer helpful?

Answer: (a) Tungsten has a very high melting point; (b) alloys have higher resistivity and do not oxidise easily; (c) in series, appliances cannot be run independently and do not get full voltage; (d) \(R \propto 1/A\); (e) copper and aluminium have very low resistivity.

(a) Tungsten is a pure metal (not an alloy). It has a very high melting point (about 3380 °C), so the filament can be heated until it glows white-hot without melting. It also has fairly high resistivity, so it gets very hot when current flows. The bulb is filled with inert gas (nitrogen/argon) so the hot filament does not burn.

(b) An alloy has a higher resistivity than its constituent metals, so it produces more heat (\(H = I^2Rt\)). Alloys also do not oxidise (burn) readily at high temperatures, so the element lasts longer.

(c) In a series circuit the same current flows through all appliances and the 220 V is shared among them, so no appliance gets its full rated voltage. The total resistance becomes large and the current small. If one appliance fails or is switched off, the circuit breaks and all others stop working. Appliances needing different currents cannot be run properly. In parallel, each appliance gets the full voltage and has its own switch.

(d) Resistance is inversely proportional to the area of cross-section: \(R = \rho \dfrac{l}{A}\). A thicker wire has less resistance; doubling the area halves the resistance.

(e) Copper and aluminium have very low resistivity, so they are good conductors and very little energy is lost as heat in the transmission wires. Aluminium is also light and cheap.

Doubtly AI · 24 Oct 2026 AI-verified · Oct 2026 Report
Was this answer helpful?

Practise this chapter

Electricity

Your answer

Log in or create a free account to answer this question.