Skip to content
doubtly

Introduction to Robot Kinematics

10 solved questions 1 note

Chapter test coming soon ← Previous

Every question from past university papers on Introduction to Robot Kinematics, newest paper first. Open any question for its full worked answer.

Mumbai University FE Sem 1 Engineering Mechanics (ESC101) Question Paper December 2025

Full paper →
  1. Q.6 (B) A simple 2 DOF planar robot is shown. Prepare a D H parameter table and perform forward kinematics to find the location and orientation of end effector B.

    Figure: base joint O on a fixed support. Link OA, 3 m long, makes 110° measured anticlockwise from the horizontal x-axis at O. Link AB, 2 m long, is turned clockwise by 65° from the extension of OA (dashed line) at joint A. B is the end effector.

    8 marks · See worked answer →

Mumbai University FE Sem 1 Engineering Mechanics (ESC101) Question Paper June 2025 (KT)

Full paper →
  1. Q.6 (A) A planar elbow manipulator is shown. Write the D H parameters and hence locate the position and orientation of the end E of the manipulator. Given \(L_1 = L_2 = 250\) mm and \(\theta_1 = \theta_2 = 30^\circ\).

    Figure: base frame \(X_0, Y_0\) at O. Link 1 (length \(L_1\)) goes from O to joint A at angle \(\theta_1\) measured anticlockwise from \(X_0\). Link 2 (length \(L_2\)) goes from A to end point E; \(\theta_2\) is measured anticlockwise from the extension of link 1 (dashed line) to link 2.

    7 marks · See worked answer →